Updated November 2026

For most treadmills, you need only a small amount of belt lubricant, usually a few teaspoons spread evenly under the belt. Manufacturers generally specify the exact quantity in the owner’s manual, and that figure should always come before any general guideline. Too little leaves the deck dry and noisy, while too much can seep toward the motor and cause slipping.

Why the Amount Matters

The running belt slides over a flat deck, and lubricant forms a thin film between the two surfaces. That film reduces friction, which lowers the load on the drive motor and limits heat buildup. A deck that is starved of lubricant produces a squeaking or rubbing sound, and the belt wears faster at the edges and in the center.

Shopping for one? See our guide: 7 Best Folding Treadmills with 20 Inch Wide Belt for Home (2026).

Excess lubricant is the more common mistake. Liquid that runs past the edges of the deck can reach the drive belt, the motor housing or the electronics underneath. Owners often report that a belt starts slipping or stalling after heavy oiling, which is usually a sign that the surplus has contaminated the drive system rather than a sign that more oil is needed.

Factors That Change the Amount

  • Belt length and width: A longer deck needs more lubricant than a short walking pad, so the owner’s manual figure is the best starting point.
  • Deck material: Some decks are designed for silicone-based products, and others require a specific formula. Check the label before applying anything.
  • Usage level: A treadmill used daily for long sessions typically needs attention more often than one used a few times a week.
  • Floor and room conditions: Dust and humidity can dry out the deck faster, so a dusty room may call for more frequent checks.

How to Apply Lubricant Correctly

  1. Unplug the treadmill and let it cool if it has been running.
  2. Lift the front edge of the belt slightly, or loosen the belt if your model requires it, so you can reach the deck.
  3. Apply the lubricant in a line along the center of the deck, using the amount the manual specifies.
  4. Spread it evenly by hand or by running the belt slowly for a minute at low speed with the power on, following the manual’s instructions.
  5. Wipe away any drips at the edges and avoid spraying near the motor or console.
  6. Test the treadmill at a slow walking speed and listen for noise before resuming normal use.

Tips to Avoid Over-Oiling

  • Start with less than you think you need. You can always add a little more later.
  • Check the belt for a dry, chalky look or a squeak before adding lubricant, rather than oiling on a fixed schedule.
  • Keep a rag nearby to catch any runoff at the sides.

What We’d Use

For a belt that needs regular care, a silicone-based treadmill lubricant made for your brand is usually the simplest choice: View on Amazon. If you prefer a product matched to a specific deck, look for one labeled for your treadmill brand: View on Amazon.

FAQ

Can I use WD-40 on a treadmill belt?

No. Petroleum-based or solvent sprays can damage the belt and deck and attract dust. Use only a lubricant the manufacturer recommends.

How often should I lubricate a treadmill belt?

There is no universal schedule. Many owners check every few months or whenever the belt sounds dry, but the owner’s manual should set the interval for your model.

What happens if I use too much lubricant?

Excess fluid can run toward the motor and drive belt, which may cause slipping or electrical problems. If that happens, unplug the unit and wipe up the excess. For persistent issues, consult a qualified technician.

Emily Parker

About Emily Parker

Emily Parker is part of our editorial team and reviews and edits our treadmills & walking pads guides, checking product details against manufacturer specifications and owner feedback.