Updated November 2026
For most Sole F80 setups, a mat should extend roughly 18 to 24 inches beyond the treadmill’s footprint on the sides and rear, so the belt has room to move and you have a safe place to step off. Measure the folded and unfolded dimensions of your unit, then add that clearance on every side. The exact size depends on where you put the machine and how you use it.
Why the Mat Size Matters for the F80
The F80 is a folding treadmill, which means its footprint changes depending on whether it is in use or stored upright. Sole specifies the running deck and overall dimensions in its manual, and those numbers are the starting point for any mat decision. A mat that only matches the base of the frame can leave the rear edge of the belt sitting on bare floor, where debris and a slight slope in the subfloor can cause problems over time.
Shopping for one? See our guide: What's the Best Folding Treadmill? 5 Top Picks Compared (2026).
A mat also protects the floor underneath from vibration and from the scuffs and small shifts that happen when the machine is moved. Owners often report that a mat sized only to the deck feels fine at first but leaves the frame’s feet bumping the edge after a few months of rolling the unit in and out.
Factors That Change the Right Size
Several things affect how big your mat should be:
- Folded versus unfolded footprint. Measure both. If you fold the F80 against a wall, the mat only needs to cover the folded base and the area you roll it across.
- Clearance to walls and furniture. Leave at least 2 feet behind the rear roller and about 1 foot on each side if you can. Less than that makes stepping on and off awkward.
- Flooring type. Carpet and hardwood behave differently under a treadmill. Carpet may need a rigid mat so the machine does not sink or rock, and hardwood usually needs a mat to limit noise and protect the finish. The Treadmill Mats and Flooring: Surface and Clearance guide covers surface choices in more detail.
- Cushioning needs. If you plan to add cushioning or a thicker pad, the mat footprint may need to be larger to accommodate the extra height and edges. See Treadmill Cushioning: What It Is and What to Check for what to look for.
How to Choose and Place Your Mat
Follow these steps to size the mat correctly:
- Check the F80 manual for the overall length and width in both the in-use and folded positions.
- Measure the floor space you have, including walls, doors and any furniture the unit will pass.
- Add 18 to 24 inches of clearance to the sides and rear of the machine’s footprint.
- Confirm the mat is flat and fully supports the base feet, not just the belt area.
- Test the setup by unfolding and folding the unit once before you commit to a final position.
Keep the mat clean and check the feet periodically for wear. The Treadmill Maintenance Supplies: What Manuals Call For article lists what manuals typically recommend for upkeep.
What We’d Use
A rubber or interlocking foam mat sized to the clearance measurements above works well for most F80 owners. Look for a product built for treadmills rather than a general exercise mat, since it will be rated for the weight and point loads involved.
- Rubber equipment mat, sized to your measured footprint: View on Amazon
- Interlocking foam floor tiles for a lighter, quieter option on hard floors: View on Amazon
FAQ
Do I need a mat if I have a folding treadmill?
A mat is not strictly required, but it helps protect the floor, reduce vibration, and keep the base stable. Most owners find it worth using, especially on hardwood or carpet.
Should the mat go under the whole treadmill or just the belt?
Cover the full base of the frame and the area where the feet sit. A mat under only the belt leaves the rear roller area and frame edges exposed.
Can I use a larger mat than I need?
Yes, as long as it stays flat and does not block the power cord or the folding mechanism. Check your manual before you place anything under the unit, and consult the manufacturer if you are unsure about clearance for your specific setup.
